Using Proximity Card; Using Access Codes; Holding A Channel Open; Toggle Mode - Progeny Chameleon Manual

Table of Contents

Advertisement

USING PROXIMITY CARD

The proximity card or key fobs simply needs to be presented to the
reader. The readers LED will give a brief blink to green to indicate the
card has been read. If the card is programmed into the system the lock will
release for the pre-set duration.

USING ACCESS CODES

Access codes can be four, five or six digits in length. To operate the code channel
simply enter one of the programmed access codes. If a correct code is entered,
the code LED will change to green and the code output relay will activate. Access
codes can be modified to indicate Duress. Note this feature must be enabled if
required. See "RESTORING FACTORY DEFAULT SETTINGS" later in this
manual.

HOLDING A CHANNEL OPEN

If a lock timer is programmed for timed operation, the operator can override this
and hold the output open. To do this, simply present a valid proximity card or
enter a valid access code. Once the output is activated and the LED indicator is
showing green, push and hold the 2 & 3 keys as a pair. This will hold open
proximity relay. Enter a valid access code and press 1 & 2 keys to latch the code
relay. To cancel the latched state of a channel simply present a card or enter a
valid access code again. In the case of the proximity channel operating the RQE
input will also cancel the latch.
HOLD OPEN CODE RELAY
1

TOGGLE MODE

If the lock time for a particular channel has been set to zero then each time a valid
card is presented or correct code is entered, the output relay will "Toggle" to the
opposite state.
Each channel has its own lock time thus either or both channels can be selected
to "toggle" or "timed" operation. One channel can be used to open a door, and the
other channel used to turn on and off a piece of equipment.

ALARMS

PDO

The purpose of the Prolonged Door Open (PDO) alarm is to act as a reminder
that a door is a security door and should not be wedged or held open for too long.
If the door sensor has been connected then each time the door is detected
2
HOLD OPEN PROX RELAY
2
Page 8
3

Advertisement

Table of Contents
loading

Table of Contents