The Input Select Menu - Sony VPH-D50Q Operating Instructions Manual

The INPUT SELECT Menu

The INPUT SELECT menu is used for selecting the
input signal.
Items that can be selected are highlighted in green.
You cannot select the items indicated in white.
V I D E O : V I D E O
INPUT
SELECT I N P U T - A
I N P U T - B
PIC
CTRL S W I T C H E R : S W ' E R 1 - 1
INPUT
SETTING
SET
SETTING
INPUT
INFO.
SEL: SET:
ENTER
VIDEO
Selects signal input from the VIDEO IN or S VIDEO
IN (or Y/C IN) connectors.
D E O
V I D E O : V I D E O
INPUT
SELECT I N P U T - S - V I D E O
I N P U T -
PIC
CTRL S W I T C H E R : S W ' E R 1 - 1
INPUT
SETTING
SET
SETTING
INPUT
INFO.
SEL: SET: ENTER EXIT: MENU
Select VIDEO or S-VIDEO in the pop-up menu.
INPUT-A
Selects signal input from the INPUT A connectors.
I N P U T - A
V I D E O : V I D E O
INPUT
SELECT I N P U T - A
I N P U T - B
PIC
CTRL S W I T C H E R : S W ' E R 1 - 1
INPUT
SETTING
SET
SETTING
INPUT
INFO.
SEL: SET: EXIT: MENU
ENTER
Notes
• When the PC-1271/1271M Signal Interface Switcher is
connected to the INPUT A connectors using the 5BNC
cables, INPUT-A cannot be selected.
• If the setting of INPUT-A in the SET SETTING menu is
incorrect, the picture may be distorted.
For details, see page 31 (EN).
I N P U T - A
EXIT: MENU
INPUT-B
Selects signal input from the connectors on the signal
interface board (not supplied) installed to the INPUT B
section.
I N P U T - A
V I D E O : V I D E O
INPUT
SELECT I N P U T - A
I N P U T - B
PIC
CTRL S W I T C H E R : S W ' E R 1 - 1
INPUT
SETTING
SET
SETTING
INPUT
INFO.
SEL: SET: EXIT: MENU
ENTER
Notes
• When the PC-1271/1271M Signal Interface Switcher is
connected to the projector via the IFB-40 Signal Interface
Board installed to the INPUT B section, INPUT-B cannot
be selected.
• If the setting of INPUT-B in the SET SETTING menu is
incorrect, the pictue may be distorted.
For details, see page 31 (EN).
SWITCHER
When the PC-1271/1271M Signal Interface Switcher
is connected to the projector, selects signal input from
the switcher.
I N P U T - A
V I D E O : V I D E O
INPUT
SELECT I N P U T - A
I N P U T - B
PIC
CTRL S W I T C H E S W E R 1 - 1
S W E R 1 - 2
INPUT
SETTING S W E R 1 - 3
S W E R 1 - 4
SET
SETTING
INPUT
INFO.
SEL: SET:
ENTER EXIT: MENU
You can select SW'ER1-1 to SW'ER2-8 in the pop-up
menu. They are always displayed in green even when
no signal is input.
Note
SWITCHER can be selected only when the IFB-40 Signal
Interface Board is installed to the INPUT B section, or when
5BNC MODE in the SET SETTING menu is set to ON.
25
(EN)