Panasonic SC-HTB900 Operating Instructions Manual page 30

Main unit displays
"F61"
≥ There is a problem with the amplifier of the
system.
≥ Disconnect the AC mains lead and consult the
dealer.
"F70 HDMI" / "U701" / "U703"
≥ Check HDMI connection.
≥ Turn off the main unit and then switch it on
again.
≥ Disconnect the HDMI cable.
"F703" / "F704"
≥ Turn off the main unit and then switch it on
again.
≥ Consult your dealer if the problem persists.
"F76"
≥ There is a problem with the power supply.
≥ Disconnect the AC mains lead and consult the
dealer.
"U704"
This system is receiving unsupported video
format signal from the input source.
≥ Change the video resolution setting on the
connected device. (Refer to the operating
instructions for the device.)
≥ If there is no image, connect the device directly
to the TV to change the settings.
"U705"
The TV's HDMI terminal connected to the main
unit or the TV's setting is not compatible with the
HDCP 2.2 playback source.
≥ Ensure to connect to the TV's HDCP 2.2
compatible terminal.
≥ Ensure the TV's HDMI HDCP setting
corresponds to HDCP 2.2.
(Refer to the operating instructions for the TV.)
30
TQBM0479
"DL ERROR"
The firmware download has failed. Press [OK] to
exit. Please try again later.
"FAIL"
Setting has failed. Read the instructions and try
again.
"LINKING"
≥ This system is trying to connect to the last
connected Bluetooth
"BLUETOOTH" is selected.
≥ This system is communicating with the wireless
router to complete the network settings.
Depending on the wireless router this process
may take a few minutes. Try moving this system
closer to the wireless router.
"NO CONNECT"
This system cannot connect to the network.
Check the network connection. ( 16)
"REMOTE " (" " stands for a number.)
The remote control and this system are using
different codes. Change the code on the remote
control. ( 18)
"WIRED LAN"
Connection to the network is via a wired LAN
connection.
≥ When setting up wireless connection, disconnect the LAN
cable from this system.
"Wi-Fi OFF"
The wireless LAN function on this system is
disabled.
≥ When setting up wireless connection, set the "Wi-Fi"
setting to "ON". ( 23)
"WAIT"
≥ This is displayed, for example, when this
system is turning off.
≥ This is flashing when the system is trying to
enter a network setting mode.
" " blinks
≥ This may occur when, for instance, the network
connection is interrupted.
device when
®