Cleaning And Maintenance - Rowenta Aqua Excel RU-6201 Manual

• Accessory holder section
EN
The accessory holder section is designed to place the unused accessories.(fig 8).
• Mechanical suction regulator
- The handle of the flexible hose has a mechanical suction regulator. By moving the suction regulator
slide, the suction power can be altered (fig 13).
3 • AFTER USE
• Switch off the appliance and unplug the cord.
• Collect the cable and hang to the hook. Make sure the cable is dry (fig 14).
• After demounting the inner barrel pieces, empty the dirty water.
• Clean and remount all the pieces and barrel (Look: Clean and Remounting The Inner Barrel Pieces.)
• Attach the motor housing and close the securing clips.

CLEANING AND MAINTENANCE

IMPORTANT Always stop and unplug your vacuum after cleaning.
.
• The drum, motor housing, wheel base and accessories should be cleaned from time to time and the
appliance should be checked regularly to prevent possible blockages.
• The drum and inner drum pieces can be washed with warm water when very dirty and should be dried
with a clean cloth before being used again.
ATTENTION Never use abrasive cleaning materials.
1 • REPLACING THE MOTOR SUCTION FOAM FILTER
• Motor suction foam filter should be cleaned periodicly. In this why, motor will be longer life and it is
power will be stronger.
• Motor suction grid should be removed from it is place by screwdriver or othet device as pulling to up
side (fig 15).
• Tap the filter out if it is only slightly clogged (after cleaning any dirty)(fig 16).
• Replace damaged or torn filters immediately. The spare filters are available from your dealer.
• Motor suction grid attach to the motor housing's place properly.
2 • CLEANING AND REMOUNTING THE INNER DRUM PIECE
• Open the securing clips and detach the motor housing.
• Eject the cone (fig 3).
• Pull the elbow with pulverizer disc from the slipway that is placed inner side of the suction inlet (fig 17).
• Detach the pulverizer disc from the elbow by turning counter clockwise (fig 16).
• You can wash all those pieces by applying the steps reverse.
IMPORTANT Check that, the rubber sealing, which is mounted inlet of the pulverizer disk, is correctly
placed or not (fig 19).
WARNING
• Check all the piece and filters regularly.
• Replace damaged or torn filters immediately.
• When there is a notable drop in the suction power, check if there is a blockage in the air flowing path.
• When the clening water got dirty, although the cleaning has not finished yet, change the dirty water
with maximum 2.0 liters fresh water.
3 • REPLACING THE CONE FOAM FILTER
• Tap the cone foam filter out if it is only slightly clogged (after cleaning any dirty) (fig 20).
• Replace damaged or torn filters immediately. The spare filters are available from your dealer.
8