Before The First Use; Mounting The Appliance - Rowenta Aqua Excel RU-6201 Manual

BEFORE THE FIRST USE

EN
1 • UNPACKING
Unpack your device, keep your guarantee slip and carefully read the operating instructions before the
first use of your appliance.
IMPORTANT Never vaccum water.
USING THE VACCUM CLEANER
1 • MOUNTING THE APPLIANCE
Unpack your device and get rid of all the labels. Keep your warranty card and read the instructions for
use carefully before using your appliance for the first time.
• Open the securing clips (fig.1) , detach the motor housing (fig.2) and place it upside down.
• Remove the cone above the drum (fig.3)
• Fill the drum with maximum 2.0 liters of fresh water by the help of the cone (fig.4).
• Check the filter of the cone (B) whether it is on the correct place or not (fig.5).
• Put the cone into the drum again (fig.6).
• Attach the motor housing and close the securing clips.
• Attach the wide end of the flexible hose to the suction inlet (fig 7).
• Attach the desired accessory to the extension tubes and attach unused accessories to the wheel base
(fig 8).
• Plug out the cord (fig 9), plug the appliance to the mains.
IMPORTANT The power cord hook should not be fastened to the vacuum cleaner while the unit is in
operation.
• Switch the appliance on (fig 10).
During cleaning, dust and dirts are stored in the drum. Other materials, such as fine powders, filtered
with special filters. After every cleaning, empty the barrel and clean it.
2 • ACCESSORIES AND CLEANING
• Dual function universal brush (b)
Universal brush has a 360° swiveling joint and can be used to clean both carpets and hard floors (fig
11). For hard surfaces press the brush button on the universal floor nozzle with brush.
• Crevice nozzle (c)
This nozzle is particulary useful for cleaning awkward corners and crevices (fig 12).
• Upholstery nozzle (d)
This nozzle is suitable for furniture, clothing, car seats etc (fig 12).
• Furniture brush (e)
The furniture brush can be used for cleaning tables, furniture, curtains bookshelves etc (fig 12).
• Heater-radiator brush (f)
Use this accessory for cleaning heaters, heater covering etc (fig 12).By the attachment of "brush for
heating radiators".
• Park position tool (g)
This accessory is used on the accessory holder section. The universal floor nozzle is hooked with exten-
sion tubes and flexible hose on it, when the appliance stored.
• Extension tubes (h)
Attach the extensions tubes.All suction nozzles can be fitted directly on to the flexible hose or the exten-
sions tubes. Either one or two tubes may be used. t is possible to use the flexible hose and tubes wi-
thout using a nozzle.
7