Initializing The Remote Control - Ada Ez Pro Quick Start Manual

The door shall open quickly and then close.
•
The "AUTO SETUP" led shall illuminate green.
•
1.7.7 PRESS and HOLD the "ENTER" pushbutton for three seconds. The following shall occur:
The "AUTO SETUP" led shall go out.
•
The second LED (not labeled) shall flash green.
•
The door shall be tuned.
•
1.7.8 To reset the controller, PERFORM the following:
a. PRESS and HOLD the "RESET" pushbutton.
b. PRESS and HOLD the "ENTER" pushbutton.
c. RELEASE the "RESET" pushbutton.
1.7.9 If further door adjustments are necessary, refer to document number 70001, "ADA EZ Installation
and Operating Instructions," and ADJUST as needed.
1.8

Initializing the Remote Control

1.8.1 To link an RF switch with a door controller, PERFORM the following:
a. PRESS and HOLD the "LEARN" pushbutton on the controller until LEDs DS8 through DS11
flash green. The controller shall remain in the learn mode for 20 seconds or until the RF signal
is received.
b. PUSH the RF pushbutton. LED DS7 shall flash green indicating that the operator accepted this
RF pushbutton.
c. REPEAT steps 1.8.1.a. and 1.8.1.b. as necessary for up to eight ADA EZ transmitters.
1.8.2 To remove all RF pushbuttons from memory, PERFORM the following:
a. While pressing and holding the "LEARN" pushbutton on the controller, PRESS and
RELEASE the "RESET" pushbutton.
© 2012 ADA EZ. ALL RIGHTS RESERVED.
700402
Rev. B, 10/30/12
15 of 15