XCMG XZ320 Operation Instructions Manual page 59

XZ320 Horizontal Directional Drill Manual
Warning! Drill shall move forward during motion on the horizontal ground or
downslope pavement and retreat during upslope or moving to tow truck to
strengthen safety precaution measures and facilitate operation.
Please operate as follows when entering into the site or finishing drilling;
2.1 Remove residual mud in mud supply system by clean water then detach
the mud mixing device.
2.2 Wash equipment and auger stem by clean high-pressure water if
possible.
2.3 Retract anchor piles.
2.4 Separate all assorting devices such as mud mixing system and pipe
connector, etc.
2.5 Overturn the operation seat to the transportation position.
2.6 Rotate the guide rail to the horizontal position.
2.7 Engine shall operate with low speed so that drill can move to the tow
truck or auto truck with low speed.
Warning: Drill shall move forward during motion on the horizontal
ground or downslope pavement and retreat during upslope or
moving to tow truck to strengthen safety precaution measures
and facilitate operation.
2.8 Guarantee firm fixation when transporting drills by truck or tow truck.
IMPORTANT: Anchorage seat must be put down during
transportation (to avoid damage to angle adjustment oil
cylinder). It can not be tied by hoisting ring on left and right
sides of crawler support by chain or rope after placing on the
carriage floor of tow truck or truck stably.
Warning: Engine shall be under low-speed operation status
when drill moves toward tow truck or truck!
56