Advertisement
R E A S S E M B L Y H I N T S & T I P S
To o l s R e q u i r e d :
wrench set
jaw vise
screwdriver
Tip 1
When installing the shaft into the
front shaft support, ensure that the
trimmed end of the shaft fits cleanly
into the support. Gently inset shaft
by hand or using a hand press.
Always use a towel or rag to protect
the shaft.
CAUTION: Before reassembling a T-MAG™ pump, carefully read the following
instructions and special procedures.
failure of the pump components or damage to an individual part making assembly
impossible.
NOTE: The steps shown in this example represents all five sizes of T-MAG™ mag-
drive pumps. The steps shown are not necessarily in order of reassembly of the
pump.
Tip 2
When installing the front wear ring
into the front buffer use a hand
press to ensure that the wear ring is
evenly inserted. Failure to ensure a
level wear surface will damage the
impeller wear ring and reduce the
life of the pump.
24
Failure to do so may result in premature
Tip 3
Before installing the flanges and o-
rings on the inlet and discharge ports,
spray the o-rings with a lubricant to
ease installation. Confirm lubricant
used is compatible with all pump
materials and process application.
Advertisement
