Interval Operation - Hasselblad X1D II 50C User Manual

I NTE RVAL OPE RATION
An active and pending Interval Timer, is indicated both on the
Control Screen and in Live View.
The Control Screen shows the Interval Icon (A) and the
Interval Time (B) . To see all settings, tap the Interval Icon to
show the settings screen as described on the previous page.
Live View and preview Screens show the same information
with the addition of remaining number of captures (C) and (D) .
To start the sequence, press the shutter release. If you have
set an initial delay to prevent camera shake, the camera will
first wait the pre-set number of seconds showing a black
screen with a count-down timer, and then start the Interval
sequence.
After a capture, the image will show up on the rear screen,
together with the Interval information.
To end the sequence before all captures have been made,
press Exit (the Star Button).
Note!
Live View is turned off during an Interval sequence.
Note!
The preview can be turned off in the " General Settings >
Preview > Rear Screen " setting.
Note!
Interval is not supported in Phocus Mobile II or when tethered
to Phocus. For tethered operation, use the Capture Sequenc-
er function in Phocus.
Note!
During a running Interval Sequence, you can press the Menu
Button to activate the Control Screen to check current status.
X1D II 50C USER GUIDE
Control Screen
A
Live View
C
Preview Screen after a capture
D
Contents
FUNCTIONS
B
www.hasselblad.com
57