Cas-Gps Node Operation; On System Start-Up - GE CAS GPS Node II User Manual

9.3

CAS-GPS Node operation

9.3.1

On System Start-up

Immediately after starting the system and before putting it into service, perform a quick check of the CAS-GPS user
interface status ICONs. Check that none of the icons are Red indicating a fault condition, if so your CAS-GPS system
is not functioning correctly and its operation and your visibility within the fleet cannot be assured!
Stationary Objects without a permanent display should have functions regularly checked on a temporarily paired CAS-
GPS user interface display as detailed in the installation manual for the stationary object.
Primary NODE
GPS Status
Primary + Secondary NODE
V2V Link & Self-Test Status
Secondary NODE
GPS Status
CAS-GPS Node II User Manual (DOCU0142)
CAS-GPS Node II User Manual
Primary + Secondary NODE
ToF Link & Self-Test Status
North
If any of the CAS Icons are red the system may not be operating correctly and the
fault must be reported for action to the fleet manager.
Depending on your system configuration at startup, the GPS will assume you are
facing 'North' until a heading has been established by forward movement.
Heading may be determined without forward movement when self-test
functionality is installed.
If a nearby vehicle's beams are overlapping your vehicles beam an audible
alarm will be sounded within the CAS-GPS application. Only when your vehicle is
stationary may you silence the alarm by touching anywhere on the screen.
Primary NODE + Display
Link Status
Rev A
Display
Wi-Fi Status
Display
GSM/WCDMA Status
Reverse Input Status
Ignition Input Status
Display
Battery Charge Status
Primary NODE
Battery Charge Status
Secondary NODE
Battery Charge Status
Page 11 of 20