Advertisement
Quick Links
Advertisement
Related Manuals for Vulcan-Hart VHU18
Summary of Contents for Vulcan-Hart VHU18
- Page 1 INSTALLATION & OPERATION MANUAL VHU18 INSULATED HUMIDIFIED HOLDING & PROOFING CABINET VULCAN 3600 NORTH POINT BLVD. DIVISION OF ITW FOOD EQUIPMENT GROUP, LLC BALTIMORE, MD 21222 800-814-2028 www.vulcanequipment.com F-47668 (02-18) Vulcan ©2016 All Rights Reserved...
-
Page 2: Important For Your Safety
VHU18 INSULATED HUMIDIFIED HOLDING & PROOFING CABINET F-47668 (02-18) IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL ELECTRICAL EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START- UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. -
Page 3: Table Of Contents
VHU18 INSULATED HUMIDIFIED HOLDING & PROOFING CABINET F-47668 (02-18) TABLE OF CONTENTS IMPORTANT FOR YOUR SAFETY INTRODUCTION INSTALLATION ELECTRICAL REQUIREMENTS OPERATION INSTRUCTIONS CLEANING REFERENCE AND TROUBLESHOOTING SERVICE & PARTS INFORMATION... -
Page 4: Introduction
VHU18 INSULATED HUMIDIFIED HOLDING & PROOFING CABINET F-47668 (02-18) INTRODUCTION The VHU18 Insulated Humidified Holding and Proofing Cabinet provides an efficient means of holding bulk prepared foods at proper serving temperatures while maintaining food quality. Advanced sensing technology maintains an ideal combination of temperature and humidity, without complicated controls. - Page 5 VHU18 INSULATED HUMIDIFIED HOLDING & PROOFING CABINET F-47668 (02-18) Fig. 1, Tray slide install 5. Install both pans by placing the VHU Interior Pan (black coated underside) in the opening above the heating element, and by sliding the VHU Exterior Pan into the underneath position.
-
Page 6: Electrical Requirements
VHU18 INSULATED HUMIDIFIED HOLDING & PROOFING CABINET F-47668 (02-18) ELECTRICAL REQUIREMENTS ELECTRICAL CODES & STANDARDS: The cabinet must be installed in accordance with: In the United States of America: 1. State and Local Codes. 2. National Electrical Code, ANSI/NFPA-70 (latest edition.) Copies may be obtained from: National Fire Protection Association, 1 Batterymarch Park, Quincy, MA 02269. -
Page 7: Operation Instructions
VHU18 INSULATED HUMIDIFIED HOLDING & PROOFING CABINET F-47668 (02-18) OPERATION INSTRUCTIONS The Cabinet and its parts are hot. Be very careful when operating, cleaning, or servicing the cabinet. Heating elements are located at the bottom of the unit. Touching the floor of the internal cavity or water pan can result in injury. - Page 8 VHU18 INSULATED HUMIDIFIED HOLDING & PROOFING CABINET F-47668 (02-18) START UP 1. Fill VHU Interior pan ½ – ¾ full of clean water (1 – 1.5 gallons). Use hot water to improve preheat times. The max capacity of the water pan is 2 U.S. gallons or 7.5 liters. NOTE: Additives such as oils, flavor enhancers, water softeners, or any products other than clean water are NOT permitted for use in this pan.
-
Page 9: Cleaning
VHU18 INSULATED HUMIDIFIED HOLDING & PROOFING CABINET F-47668 (02-18) END OF OPERATION – SHUT DOWN 1. Turn the unit OFF using rocker switch. 2. Leave the door in an open position (at least 2" gap) for at least 30 minutes to remove moisture and cool down. -
Page 10: Reference And Troubleshooting
VHU18 INSULATED HUMIDIFIED HOLDING & PROOFING CABINET F-47668 (02-18) REFERENCE AND TROUBLESHOOTING Symptoms Possible causes Remedy Cabinet not connected to Connect cabinet to power source power source Cabinet not operating Check circuit breaker No power Check GFCI Dry moisture problem. Find and fix root... -
Page 11: Service & Parts Information
VHU18 INSULATED HUMIDIFIED HOLDING & PROOFING CABINET F-47668 (02-18) TABLE providing AUTO/MAX/MIN Relative Humidity for each Temperature. Auto-set Temperature Relative Relative Relative (˚F) humidity (%) humidity (%) humidity (%) SERVICE & PARTS INFORMATION To obtain Service and Parts information concerning this model, and for a complete listing of Authorized Service and Parts depots refer to our website or call Customer Service.