Advertisement
SAFETY INSTRUCTIONS
Important safety warns
This device has left the factory in perfect condition.
In order to maintain this condition and to ensure a safe operation, it is absolutely necessary for the
user to follow the safety instructions and warning notes written in this user manual.
Important: Damages caused by the disregard of this user manual
are not subject to warranty.
The dealer will not accept liability for any resulting defects or problems.
If the device has been exposed to temperature changes due to environmental changes, do not switch
it on immediately. The arising condensation could damage the device.
Leave the device switched off until it has reached room temperature.
This device falls under protection-class I. It is essential that the device be earthed.
If protection screen, lens or ultraviolet screen in the fixture is apparently damaged or is damaged
to exceed their own effective degree, such as cracked and gashed, it must be replaced.
The electric connection must carry out by qualified person.
Make sure that the available voltage is not higher than specified.
Make sure the power cord is never crimped or damaged by sharp edges.
If this would be the case, replacement of the cable must be done by an authorized dealer.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle
the power cord by the plug.
Never pull out the plug by tugging the power cord.
During initial start-up some smoke or smell may arise.
This is a normal process and does not necessarily mean that the device is defective, it should
decrease gradually.
Please don't project the beam onto combustible substances.
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by
the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
Please be aware that damages caused by manual modifications to the device
are not subject to warranty. Keep away from children and non-professionals.
Advertisement
