Emerson K-BALL F110 Operating And Safety Instructions

K-BALL PED - BALL VALVES
OPERATING AND SAFETY INSTRUCTIONS
Before installation these instructions must be fully read and understood
CONTENTS
1 - Protection / Storing
2 - Installation / Operation
3 - Maintenance
This sheet applies to the following products:
F110-F120-F130-F133-F138-F150-F170-
F180-F190.
These products have been designed,
manufactured and tested under the supervision
of a certified Quality Assurance system in
accordance with Module H (categories I, II and
III) of Annex 3 of European Directive 97/23/CE
concerning pressure equipment.
The products are designed to guarantee your
safety during the installation, operation and
maintenance under the condition of applying
the following recommendations, of respecting
the conditions of use defined in the technical
data sheets of the products and not being in an
exceptional situation. The products covered by
this document are standard valves in manual
version or actuated version. For the other
products, a complementary instruction sheet
will be attached if required.
It is imperative that these instruction sheets
accompany the products to their final
destination. The control of the distribution of
these documents, translated into the language
(*) where the end-user is located, is under your
responsibility.
(*) This only applies to European countries.
Emerson.com/FinalControl
1 - PROTECTION / STORING
Protection
Except for particular customer specification at
the time in the order, the valves are delivered
in conformity with Emerson packaging
procedures. The package ensures the
protection of the product against the shocks
in the conditions of road and railway transport
and of storage in clean and dry premises.
The protection caps mounted on the valves,
in order to protect the seats and discs from
ulterior damages, must not be removed
before the moment of the installation of the
valve on the line. For storing or transporting
in conditions different from those mentioned
above, it belongs to the customer to condition
the product in an adapted way to protect it or to
specify it in the order.
Storing
The storing must be done separate from the
ground in a dry location, and indoor.
In the case the valves are delivered with
watertight package with a desiccative product
(provided for a long storing time before
installation), the desiccative product bags must
be replaced for any storing period exceeding 6
months. The package must be kept watertight
again.
© 2017 Emerson. All Rights Reserved.
VCOSI-01684-EN 16/07