Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for SCHUNK SST
Summary of Contents for SCHUNK SST
- Page 1 Original operating manual Assembly and operating manual Sensor tester...
- Page 2 Imprint Copyright: This manual is protected by copyright. The author is SCHUNK GmbH & Co. KG. All rights reserved. Any reproduction, processing, distribution (making available to third parties), translation or other usage - even excerpts - of the manual is especially prohibited and requires our written approval.
-
Page 3: Table Of Contents
6.1.2 Connection of a sensor with an open wire strand........ 9 Operation of the SST with a sensor .............. 9 Maintenance and care .................... 10 Maintenance ...................... 10 Battery change .................... 10 Troubleshooting ..................... 11 04.00 | SST | Assembly and operating manual | en | 389581... -
Page 4: General
Parts touching the workpiece and wear parts are not included in the warranty. 1.3 Scope of delivery The scope of delivery includes • Sensor tester SST in the version ordered • Assembly and Operating Manual • Accessory pack 04.00 | SST | Assembly and operating manual | en | 389581... -
Page 5: Basic Safety Notes
2 Basic safety notes 2.1 Intended use The SST sensor tester is used to test and adjust proximity switches from SCHUNK, i.e. the IN, INK, MMS and RMS products. The module may be used only in the context of its defined application parameters. -
Page 6: Technical Data
Inductive, capacitive and optoelec- tronic sensors (3-conductor DC, 2- conductor DC and NAMUR) More technical data is included in the catalog data sheet. Whichever is the latest version. 04.00 | SST | Assembly and operating manual | en | 389581... -
Page 7: Design And Description
The switching function is signaled by an LED and an additional acoustic signal. When not in use, the sensor tester automatically switches itself off after approx. 30 seconds. The necessary power is supplied by a 9 V compound battery 04.00 | SST | Assembly and operating manual | en | 389581... -
Page 8: Assembly
Assembly 5 Assembly The Sensor tester SST can be fastened by means of the lateral through-bores if necessary. 1 Through-bores Ø 5.5 04.00 | SST | Assembly and operating manual | en | 389581... -
Page 9: Operation
If the LED (3) lights up in red, the battery needs to be ✓ changed. If the sensor is damped, the SST emits a signal and the LED (4) Ø lights up in orange. If the status of the sensor changes from damped to undamped, Ø... -
Page 10: Maintenance And Care
Remove old batteries and dispose of them properly. Ø Insert new battery. Ø Battery type: 9V compound battery 6LR61 Close the battery compartment cover and snap the lock in place. Ø 04.00 | SST | Assembly and operating manual | en | 389581... -
Page 11: Troubleshooting
The battery is empty or does not have contact. The red LED lights up. The battery is almost empty. Change the battery. Orange LED lights up PNP/NPN switch is set incorrectly. continuously. 04.00 | SST | Assembly and operating manual | en | 389581... - Page 12 04.00 | SST | Assembly and operating manual | en | 389581...
Need help?
Do you have a question about the SST and is the answer not in the manual?
Questions and answers