Installing Memory Modules - Sony PCV-RXP-RZP System Reference Manual

Installing Memory Modules

Your system supports PC2700 DDR-SDRAM memory modules. The
DDR-DIMM memory modules can be single- or double-sided and
installed in either socket.
!
Before opening the system unit, save and close all open files, exit all open
applications, turn off the power to all attached peripheral devices, shut
down the computer, and unplug the power cord.
1
Choose the size of the memory module and configuration as shown
in the following table. Memory modules can vary in size and speed
between sockets. The minimum memory size is 128 MB. The
maximum memory size is 1.0 GB. The BIOS automatically detects the
type, size and speed of the memory modules.
Memory module configurations (MB)
DIMM1
0, 128, 256, 512
* Your computer ships with at least 512 MB of memory and is expandable to 1.0 GB. Your model may
ship with more than 512 MB SDRAM depending on the configuration you purchased.
✍
Use only PC2700 memory. Your system does not support EDO, buffered
DDR-SDRAM, or PC100/133 SDRAM memory.
2
If necessary, remove the memory module you wish to replace (see
"Removing a Memory Module"
!
Touch any exposed metal portion of the chassis to discharge static
electricity in your body before handling a memory module.
3
Remove the new memory module(s) from its anti-static package.
Hold the memory module only by its edges to prevent
static-electricity damage.
4
Remove the side panel (see
5
Remove the power supply (see
(PCV-RX series models)"
!
Do not remove the Giga Pocket™ card (located in PCI slot No. 3) unless
directed by a service technician. The Giga Pocket card is a fragile
hardware component.
* Applicable to PCV-RX models only.
Upgrading and Maintaining Components
"Removing the Side Panel"
"Removing the Power Supply
on page 49).
*
DIMM2
0, 128, 256, 512
on page 36).
*
39
on page 24).