Advertisement
2
From the Toolbox Screen, use the → arrow un l you see the Version
Screen.
2GIG-TS1 Version Screen
Control Panel Version Screen
REGULATORY INFORMATION
Wireless Product Notice
Radio controls provide a reliable communications link and fill an
important need in portable wireless signaling; however, there are some
limitations which must be observed.
•
For U.S. installations only: The radios are required to comply with
FCC Rules and Regulations as Part 15 devices. As such, they have
limited transmitter power and therefore limited range
(approximately 400 ft.).
•
A receiver cannot respond to more than one transmitted signal at a
time and may be blocked by radio signals that occur on or near their
operating frequencies, regardless of code settings.
•
Changes or modifications to the device may void FCC compliance.
•
Infrequently used radio links should be tested regularly to protect
against undetected interference or fault.
•
A general knowledge of radio and its vagaries should be gained prior
to acting as a wholesale distributor or dealer, and these facts should
be communicated to the end users.
FCC NOTICE
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for
Class B Digital Device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures.
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
Les changements ou modifications non approuvés expressément par la
partie responsable de la conformité pourrait annuler l'autorité de
l'utilisateur à faire fonctionner l'équipement.
Industry Canada Notices
This device complies with Industry Canada licence‐exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Repairs to certified equipment should be made by an authorized
Canadian maintenance facility designated by the supplier. Any repairs or
alterations made by the user to this equipment, or equipment
malfunctions, may give the telecommunications company cause to
request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground
connections of the power utility, telephone lines and internal metallic
water pipe system, if present, are connected together. This precaution
may be particularly important in rural areas.
Users should not attempt to make such connections
WARNING:
themselves, but should contact the appropriate electric
inspection authority, or electrician, as appropriate.
Operating and Storage Temperature
The recommended storage temperature for all Touch Screens is ‐10°C to
60°C (14°F to 140°F).
For optimal Touch Screen use, operational temperature is 0°C to 49°C
(32°F to 120°F).
LIMITED WARRANTY
This 2GIG Technologies product is warranted against defects in material
and workmanship for 1 year. This warranty extends only to wholesale
customers who buy direct from 2GIG Technologies or through 2GIG
Technologies' normal distribution channels. 2GIG Technologies does not
warrant this product to consumers. Consumers should inquire from their
installing dealer as to the nature of the dealer's warranty, if any.
There are no obligations or liabilities on the part of 2GIG Technologies
for consequential damages arising out of or in connection with use or
performance of this product or other indirect damages with respect to
loss of property, revenue, or profit, or cost of removal, installation, or
reinstallation. All implied warranties for functionality, are valid only until
the warranty expires. This 2GIG Technologies Warranty is in lieu of all
other warranties expressed or implied.
For technical support in the USA and Canada:
855‐2GIG‐TECH (855‐244‐4832)
Email: techsupport@2gig.com
Internet: dealer.2gig.com
Visit web site for technical support hours of operation
For technical support outside of the USA and Canada:
Contact your regional distributor
Visit dealer.2gig.com for a list of distributors in your region.
PN 77‐000090‐001 Rev. D
©2013 2GIG Technologies Inc. All Rights Reserved.
5
Advertisement
