Related Manuals for Heritage Bathrooms Freestanding Furniture & Wall Hung Cabinet
Summary of Contents for Heritage Bathrooms Freestanding Furniture & Wall Hung Cabinet
- Page 1 Installation Guide Models covered: Freestanding Furniture & Wall Hung Cabinet Please keep this booklet for future Reference. Installer: when you have read these instructions please ensure you leave them with the user.
-
Page 2: Table Of Contents
Introduction Thank you for buying a Heritage Product. When you buy a Heritage product, you can be confident that it not only features a beautiful, distinctive, classic design, but that it has also been made to the very highest quality standards. -
Page 3: Safety Notice
Safety Note Please read these instructions and retain for future use. All products manufactured and supplied by Heritage are safe, provided they are installed correctly, used correctly, and receive regular maintenance in accordance with these instructions. If you are in any doubt about your ability to install this product safely you must employ the services of an competent person who has experience of fitting products of this nature. -
Page 4: Installation
Installation of Vanity Units We recommend that you secure the unit to the wall using angled brackets (not supplied). Position the cabinet in your required location checking the alignment with a spirit level and mark the wall through the holes in the angled brackets. - Page 5 Installation of Vanity Units Locate the basin so it is evenly flush with the edges and firmly against the rear wall. Fasten basin to the wall using screws (not supplied) or bolts (supplied, if applicable). The holes for these can be seen on the rear of the basin. Once basin is fixed to the wall, run a bead of silicon around the joint between the basin and the vanity unit, this will ensure the furniture is sealed from water.
- Page 6 Installation of Wall Cabinets Centre 21.6 21.6 Recommended Fixing diameter 6mm Determine favoured position of cabinet and mark a vertical centre point on the wall. Measure the span of the pre-fitted brackets and transfer measurement to wall measurement out from centre point to give a central position for the cabinet.
- Page 7 Installation of Wall Cabinets Cabinet hangers should only be adjusted with a hand tool and not a power tool Vertical and horizontal adjustments Turn the top adjustment screw to adjust the unit from front to back. Allows unit to tilt forwards or backwards from the wall.
- Page 8 Installation of Tall Boy Units or Small Storage Units View from rear Tall boy units can be attached to the wall using the shown security bracket. There is a purpose access hole drilled for this on the lower part of the unit, use the provided screw and washer to attach the bracket to the unit.
-
Page 9: Shelf Positioning
Shelf Positioning Push the shelf dowels into pre-drilled holes. Offer shelf into cabinet at an angle, allowing positioning and lower into place. Adjustment of doors All hinges for the cabinets are already installed but may need adjustment to line up the door to the frame. Alters tilt of doors Pushes door in or out from unit... -
Page 10: Caring For Your Product
Caring for your product Your fitting has a high quality finish and should be treated with care to preserve the visible surface. A few tips for preventing defects from forming: Occasionally wipe the surface with a soft damp cloth and dry with a soft dry cloth. Do no use any abrasive cleaning agents or materials, these will change the surface condition from the standard finish. -
Page 11: Notes
Notes... - Page 12 Contact Details Heritage Bathrooms Birch Coppice Business Park Dordon Tamworth B78 1SG Website: www.heritagebathrooms.com Customer Services Telephone: 0330 026 8503 Email: technical@heritagebathrooms.com Freestanding Furniture - D4...
Need help?
Do you have a question about the Freestanding Furniture & Wall Hung Cabinet and is the answer not in the manual?
Questions and answers