To Return The Access Point Settings To The Factory Default Settings; Mac Address - Sony PCWA-A500 Operating Instructions Manual

5ghz wireless lan access point

Hide thumbs Also See for PCWA-A500:

Table of Contents

To return the Access Point settings to the factory default settings

To return the Access Point settings to the factory default settings, hold

down the factory default switch for approximately one second while the

power of the Access Point is ON. For information on the location of the

factory default switch position, see "Names of parts and functions" on

page 9.

About the indicator display

When you press the factory default switch, the MESSAGE indicator flashes

orange. If you continue to press this switch, the WIRELESS, NETWORK

1, and NETWORK 2 indicators flash green, and the operation to return the

Access Point settings to the factory default settings begins. When the

indicators stop flashing, the Access Point settings have been returned to the

factory default settings. For setting details, see page 12.

Note

If you perform this procedure, all previously set data will be lost.

You can check the MAC address for the Access Point NETWORK 1

connector on the Status Display screen. For details, see "Confirming the

status of the Access Point" (page 21).

Table of Contents