OHAUS CKW Series Quick Start Manual

Buy your next Ohaus Balance online at https://scaleman.com/
Quick Start Guide

ASSEMBLY

Carefully lift indicator out of box: its cable is
attached to the load cell through the column.
Position Indicator bracket in column assembly.
Insert screws and adjusting knobs. Tighten
enough to secure Indicator. Adjust to desired
tilt, then finish tightening adjusting knobs.
Place the weighing platform on the scale.
Power
Check that local line voltage matches voltage
printed on the scale's indicator label. Then
connect the scale to the power supply.

SELECTING THE LOCATION:

Place on a firm, steady surface with sufficient space. Avoid excessive
air current, vibrations, heat sources, or rapid temperature changes.

SAFETY PRECAUTIONS

For safe and dependable operation of this product, observe the following safety
precautions:
Verify that the input voltage printed on the indicator label and the plug type matches
•
the local power supply.
Be sure the power cord does not pose an obstacle or tripping hazard.
•
Disconnect the product from power supply when cleaning.
•
Do not operate this product in hazardous or unstable environments.
•
Do not drop loads on the platform.
•
Use only approved accessories and peripherals.
•
Operate the product only under ambient conditions specified in the Instruction Manual.
•
Service should be performed by authorized personnel only.
•
Ohaus Corporation www.ohaus.com
Visit www.balances.com to see the full line of Ohaus Balances
CKW Scales
i CKW Series Scales Quick Start Guide
Adjusting knobs
and screws
Weighing
platform
Level Bubble
at rear
Leveling Feet
Level the scale:
Adjust feet so bubble
is centered.