Assembly Instruction - Echanfit CBK1902 User Manual

ASSEMBLY INSTRUCTION:

1.PREPARATION:
A. Before assembling make sure that you will have enough space around the item.
B. Use the present tooling for assembling.
C. Before assembling please check whether all needed parts are available (at the above
of this instruction sheet you will find an explosion drawing with all single parts (marked
with numbers) which this item consists of.
2.ASSEMBLY INSTRUCTION:
:
FIG.1
FIG.2
FIG.1:
Attach the Front Stabilizer (pt.15) to
the Main Frame (pt.16) using two sets of
Ø10 Flat Washers (pt.5), M10 Domed
Nut (pt.6) and M10*55 Carriage bolt (3).
Attach the Rear Stabilizer (pt.4) to the
Main Frame (pt.16) using two sets of Ø10
Flat Washers (pt.5), M10 Domed Nut
(pt.6) and M10*55 Carriage bolt (3).
The aluminum alloy kettle frame (19) and
the screw (21) are fixed on the main
frame (16) with a cross screwdriver.
FI G.2:
First, the elastic bolt (7) of the large ball
head is loosened and pulled down, then
the cushion adjusting pipe assembly (10)
is inserted into the inner liner of the main
frame assembly (16) to make it in an
appropriate position, and then the elastic
bolt (7) of the large ball head is loosened
and locked. At the same time, the buffer
sliding tube assembly (12) is inserted into
the buffer regulating tube assembly (10)
and the elastic bolt (7) of the large ball
head is locked by the buffer. Finally, the
buffer pad (13) is locked with a tool (using
a cross wrench).
7