Navigation - Sevcon MillipaK Manual

Calibrator Calibrator/Navigation
______________________________________________________________________________

Navigation

The Calibrator uses all three buttons for navigating through the menu structure.
Use the SELECT button to move through the menu structure. When the SELECT button is
pressed the next menu item is displayed. The default direction is from left to right, top to bottom.
If the ' +' and ' -' buttons are held down together, the ID of the currently displayed menu item is
shown. For example, if the Current Limit personality was selected, then the ID would be 0.01
(menu 0, item 1). This allows the operator to locate where they are in the map.
If the ' +' and ' -' buttons are held down together for more than 3 seconds, the direction through the
menu structure is reversed. Now when the SELECT button is pressed the direction is from right to
left, bottom to top. In this mode, the LED on the Calibrator will flash. If the ' +' and ' -' buttons are
held down together for more than 3 seconds again, the direction reverts back to the first direction
and the Calibrator LED stops flashing.
The SELECT button is used to navigate through most of the menu structure, however, the Test
menu (menu 19) is slightly different. Pressing the SELECT button will take you to the first item
in the Test menu, (item 19.01 - Accelerator Demand). To navigate the Test menu, you need to use
the ' +' and ' -' buttons. The ' +' button moves up the Test menu and the ' -' button moves back down.
Pressing the SELECT button at any time exits the Test menu and moves to the first item in the
menu structure (menu item 0.01 – Lift Speed 1).
The items which are displayed depends on the current system configuration and the Security
Level.
MillipaK PUMP Controller Manual Page 12 07/11/05