Specifications - Sony TCD-D8 Operating Instructions (primary manual) Operating Instructions Manual

Specifications

Tape
Recording time
Sampling frequency
Frequency response
Signal to noise ratio
Dynamic range
Total harmonic distortion
Wow and flutter
Input
MIC
LINE IN
Output
Jack type
PHONES/ stereo
LINE OUT minijack
Input/Output
Power requirements
Battery life (when the
illumination for display
window is off)*
Power consumption
Dimension
Mass
Digital audio tape
Standard 120 minutes
Long-play mode: 240 minutes
(with DT-120)
48 kHz, 44.1 kHz, 32 kHz
Standard: Fs 48 kHz 20-22,000 Hz (±1.0 dB)
Fs 44.1 kHz 20-20,000 Hz (±1.0 dB)
Fs 32 kHz 20-14,500 Hz (±1.0 dB)
Long-play mode: Fs 32 kHz 20-14,500 Hz (±1.0 dB)
Standard: more than 87 dB
Long-play mode: more than 87 dB
(1 kHz IHF-A, 22 kHz LPF, LINE IN)
Standard: more than 87 dB
Long-play mode: more than 87 dB
(1 kHz IHF-A, 22 kHz LPF, LINE IN)
Standard: less than 0.008% (1 kHz, 22 kHz LPF, LINE IN)
Long-play mode: less than 0.09% (1 kHz, 22 kHz LPF, LINE IN)
Below measurable limit (less than ±0.001% W.PEAK)
Jack type Impedance
stereo minijack 4.7 kilohms
stereo minijack 47 kilohms
Impedance Rated output
27 ohms LINE OUT
500 mV
DIGITAL I/O REMOTE jack (special jack)
Digital input/output, remote control operation and
possible by connection with an adaptor kit to this jack.
• DC 6V four size AA (LR6) batteries
• DC IN 6 V jack accepts:
the Sony AC power adaptor AC-E60AM or AC-E60HG (not supplied) for
use on 120 V AC, 60 Hz
the car battery cord DCC-E160L (not supplied) for use with 12 V car battery
or DCC-E260XL, DCC-E260HG (not supplied) for use with 12V/24V car
battery.
Sony alkaline (size AA) LR6/AM3
Sony rechargeable (size AA) NC-AA
* Measured at 20°C
**When the headphones or active speaker system is unplugged from the PHONES/
LINE OUT jack
1.2 W
Approx. 132.6 x 36.7 x 88.2 mm (51/4 x 11/2 x 31/2 in) (w/h/d)
not incl. projecting parts and controls
Approx. 510 g (1 lb. 1 oz.) incl. batteries
Rated input level Minimum input level
——
500 mV
Maximum output level
PHONES
5 mW + 5 mW
PHONES 32 ohms
timer-activated operation is
Playback
(recording monitor)
3.5
2
Additional Information
0.4 mV
80 mV
Load impedance
LINE OUT
more than
10 kilohms
(Approx. hours)
Recording
3 (4**)
1.5 (2**)
35 EN