CHAPTER 2 - Adjustment
2.2 Personalization
All the amplifier adjustments are present
on the 3.005.4 Pc board the adjustment
zone.
The amplifier is provided with 7+7 pin
header where we mount personality
components.
If an amplifier is replaced,it is important
to verify that the new amplifier is
calibrated as the one removed.
This is easily accomplished by simply
installing the personality header from the
removed amplifier into the new one and
verify the solder bridges.
Personality
header
Adjustment on the personality header
For calculate the
correct
see page 26
Service Guide MINI SPEED
Dynamic adjustment
RDT RESISTANCE
If
we
tachogenerator costant with input amplifier costant.
If the KE costant is small,we can bridge this
resistance.(see velocity calibration chapter 4.3)
value
The same also if a very low speed is requested.
pin 1 - 14
insert
this
resistance,we
Adjustement
Zone
Personality
header
Solder side
adapt
AXOR
High Performans servo Drives
'
KE