Table of Contents
Advertisement
Quick Links
UNPACKING
Immediately after unpacking the slicer, check it for possible shipping damage. If you find the machine
damaged after unpacking, save the packing material and contact the carrier within 15 days from
delivery.
Before installation, test the electrical service to assure that it fits with the specifications on the machine
data plate 1
.
ELECTRICAL
Warning: THIS MACHINE IS PROVIDED WITH THIS PLUG
TO PROPER GROUND PLUG, GROUNDED OUTLET. IF THERE IS NO GROUND PLUG, CONTACT
AN ELECTRICIAN.
CLEANING
This machine must be thoroughly cleaned and sanitized after installation and before being put into
service.
SAFETY
SAFETY DEVICES INCORPORATED IN THIS SLICER MUST BE IN THEIR
CORRECT OPERATING POSITIONS ANYTIME THE SLICER IS IN USE.
The blade cover 6
The Iast slice device 4 must be used when slicing, it keeps your hands away from the knife.
INSTALLATION
INSTALLATION
must be in position over the knife and secured by tightening the hand knob. 7
Filename: Man_AX-S_C13N_GB.PMD 14/01/11
1/4
SLICER
AX-S 13G
AX-S C13/N
C33F/N
. IT MUST BE CONNECTED
GB
Advertisement
Table of Contents
Related Manuals for MVP Axis AX-S 13G
Summary of Contents for MVP Axis AX-S 13G
- Page 1 INSTALLATION SLICER MAINTENANCE AX-S 13G AX-S C13/N C33F/N INSTALLATION UNPACKING Immediately after unpacking the slicer, check it for possible shipping damage. If you find the machine damaged after unpacking, save the packing material and contact the carrier within 15 days from delivery.
- Page 2 When the slicer is not running, the slicer thickness control 2 must be set on zero (fuIly clockwise) to cover the blade edge. Always UNPLUG the power cord before cleaning or moving the slicer. SLICING PuII the product holder 3 towards you until it stops and place the product to be sliced on the product holder tray.
- Page 3 MAINTENANCE Attention Use protection gloves BLADE SHARPENING Your slicer blade will provide long service in normal deli, food store, or commercial kitchen use. Clean the blade removing any greasy residue Make sure that the machine is off. Rotate the slice thickness control 4 to zero to make sure that the blade is covered by the slice thickness plate 5 .
- Page 4 Lift and rotate 180 degrees the sharpener and reallocate it into its initial position. Lower the sharpener cover. Cleaning of the grinding wheels To obtain an excellent sharpening the grinding wheel must always be clean. Remove dirt and grease with alcohol and the supplied special brush.
Need help?
Do you have a question about the Axis AX-S 13G and is the answer not in the manual?
Questions and answers