Welding Parameters - Bosch PSI 6XXX.350 L1 Series Technical Information

9.4

Welding Parameters

1070 080 067-101 (2001.03) GB
PSI 6XXX.350 L1
If the timer has already been programmed, the Quick-Programming will give you a good
overview of the most important Welding Parameters.
Use function key <F9> to change from Operation to Programming.
D
Check the Welding Parameters of all programs used.
D
- Sequence
Check the sequence parameters, in particular, the [Weld Times] and the
D
[%I] values (%I or kA).
- Stepper, Monitor Stepper
Recommendation: First use a simple [Sequence] without electrode mainte-
nance (stepping). The Steppers can be programmed towards the end of
commissioning.
- Current and Time Monitoring
Turn Current and Time Monitoring on. For as long as you do not know the
D
real conditions, you should use fairly large tolerances initially.
NOTE
For the subsequent production process, you should define smaller tolerances for moni-
toring in order to assure the quality of your products.
- Pressure and Pressure Stepper
Recommendation: You should first use a simple [Sequence] without Pressure and
Pressure Stepper. These values can be programmed towards the end of commis-
sioning.
Commissioning
9-7