Routine Maintenance; When You’re Done - Bissell 1960 User Manual

Routine Maintenance

When you're done
Turn Power Switch to OFF (
1.
Unplug Power Cord from outlet.
2.
Remove and empty Dirty Water Tank.
3.
a. Press detent Pedal and tip Handle back, laying it
gently on floor.
b. Release Dirty Water Tank latches [1 each side] by
pulling up from bottom of latch and then out.
c. Carefully lift Dirty Water Tank from Lower Body.
d. Carry Dirty Water Tank to a toilet or sink. To empty,
pour out contents using opening at back of Tank.
e. Fill Dirty Water Tank with clean water through the
Vent Cover and rinse thoroughly. Discard water.
f. Remove lint and hair from Red Gasket in base of unit.
(Do not remove gasket)
Replace Dirty Water Tank on Lower Body and secure
4.
with latches.
Wrap Power Cord around Quick Release Cord Wrap
5.
side of QUICKSTEAMER ® .
Wipe all surfaces with a soft cloth. Store cleaner upright
6.
in a protected, dry area.
NOTE: You may have cleaning solution remaining
in the Clean Water Tank. You may store your
QuickSteamer this way for the next cleaning
task, but never keep soiled solution in the Dirty
Water Tank.
) position.
™ on
d.
WARNING:
To reduce the risk of
injury from moving parts
and/or electrical shock,
turn Power Switch OFF
and disconnect polarized
plug from electrical
outlet before performing
troubleshooting checks.
a.
b.
e.
Vent
Cover
CAUTION:
Do not store unit where
freezing may occur.
Damage to internal
components may result.
c.
9