Using The Product - Konica Minolta Accurio Label 190 Safety Information Manual

2.1 Warnings and Precautions for Main Body
Do not let any object plug the ventilation holes of this prod-
uct. Heat could accumulate inside the product, resulting in a
fire or malfunction.
Whenever moving this product, be sure to disconnect the
power cord and other cables. Failure to do this could damage
the cord or cable, resulting in a fire, electrical shock, or
breakdown.
When moving this product, always hold it at the locations
specified in the User's Guide or other documents. If the unit
is moved while held at locations other than those specified, it
may fall, causing severe personal injury.
2.1.3

Using the Product

Do not modify this product, as a fire, electrical shock, or
breakdown could result. If the product employs a laser, the
laser beam source could cause blindness.
Do not attempt to remove the covers and panels which have
been fixed to the product. Some products have a high-volt-
age part or a laser beam source inside that could cause an
electrical shock or blindness.
Do not keep using this product, if this product becomes inor-
dinately hot or emits smoke, or unusual odor or noise. Imme-
diately turn OFF the pow-er switch, unplug the power cord
from the power outlet, and then call your Technical Repre-
sentative or your authorized service representative. If you
keep on using it as is, a fire or electrical shock could result.
Do not keep using this product, if this product has been
dropped or its cover damaged. Immediately turn OFF the
power switch, unplug the power cord from the power outlet,
and then call your Technical Representative or your author-
ized service representative. If you keep on using it as is, a fire
or electrical shock could result.
Do not use flammable sprays, liquids, or gases inside or near
this machine. Do not clean the inside of this machine using a
flammable gas duster. A fire or explosion could result.
<If an RFID module (limited only to 13.56 MHz) for use in in-
side-the-machine proximity communication or electromag-
netic induction heating (IH) technology (limited only to 20.05
kHz to 100 kHz) is being used>
This machine generates a weak magnetic field. If you experi-
ence any unusual symptoms with your implantable medical
equipment (cardiac pacemaker, etc.) while near the machine,
move away from the machine and see a doctor immediately.
Please call your Technical Representative or your authorized
service representative if you do not understand the pur-
chased product corresponds or not.
<If a non-contact IC card reader is being used>
If you use an implantable medical equipment (cardiac pace-
maker, etc.), do not bring the IC card reader close from the
implant within 12 cm at all times. The radio waves may affect
implantable medical equipment (cardiac pacemaker, etc.)
operations.
Accurio Label 190/bizhub PRESS C71cf
2
2-5