Fujitsu ASYG07-09-12KPCA Operating Manual page 3

: The setting must be done while the setting screen is
displayed for each function.
: The button is controllable only when the air conditioner is
operating.
: The instruction is relating to the wireless LAN control
(optional).
Signal transmitter
Aim at the signal receiver of the indoor unit properly.
• Operating range is approximately 7 m.
• [ ] will appear when the signal is transmitted.
• The indoor unit will emit a beep when it receive the signal
properly. If there is no beep, press the button again.
For Powerful operation ................. Refer to page 5.
Activates or deactivates the Powerful
operation.
For Energy saving operation ........ Refer to page 5.
Activates or deactivates the Economy
operation.
Do not press this button in normal use.
It starts the test run (for use by authorized service personnel only).
NOTES: If the test run starts unintentionally, press
test run.
In this section, all the possible indicators are displayed for
description. In actual operation, the display is linked with the
button operation, and only shows the necessary indicators for
each setting.
For Basic operations ..................... Refer to page 4.
Starts or stops the air conditioner operation.
Changes the operation mode.
Adjusts the setting temperature.
For Airfl ow settings ....................... Refer to page 4.
Controls the fan speed.
Controls the vertical airfl ow direction.
Sets the automatic Swing operation.
Replacing batteries (R03/LR03/AAA x 2)
1~3. Put batteries as shown in the fi gure above.
4. Press
ballpoint pen or other small object.
NOTES:
• Use specifi ed type of batteries only.
• Do not mix diff erent types or new and used batteries together.
• Batteries can be used about 1 year in ordinary use.
• If the remote control range noticeably shortens, replace the batteries.
For Timer operations ..................... Refer to page 5.
Activates or deactivates the Sleep timer.
Sets the Off timer.
Sets the On timer.
By pressed down, enters the wireless LAN
setting mode. (Refer to page 7.)
Cancels the timer setting.
By pressed down, activates or deactivates the
wireless LAN control. (Refer to page 8.)
Deactivates the timer setting.
to quit the
En-3
Remote controller display
4
2
3
RESET
1
as shown in the fi gure above. Use a tip of a