Table of Contents
Advertisement
Quick Links
Instruction manual
EN
Audio baby monitor with nightlight projector
Thank you for purchasing NUVITA 3015 TULE STARRY AUDIO BABY MONITOR. Our product has been
manufactured and checked under the strictest possible quality control to ensure that each monitor leaves the
factory in perfect condition. In the unlikely event you find any defects or have any problem, please contact our
dealer or service center.
Please read this manual carefully to obtain maximum performance and extended service life from the unit.
ABOUT NUVITA TULE
Nuvita TULE-equipped products can automatically select free channel or hop to free channel during
communication to avoid interference from other electronic devices. In addition, Nuvita TULE technology allow
our products to detect the signal power between the baby unit and parent unit, then automatically reduces
the emission power from baby unit when the two units are in close vicinity. As a result, the level of radiation to
baby is greatly reduced and always at the minimal level. Nuvita TULE technology helps to protect the baby's
health for now and future.
DECT and 2.4GHz solution are most common wireless technology applied in baby monitor telecommunication.
DECT is Digital Enhanced Cordless Technology, widely used in household wireless telephones. 2.4GHz solution
is using the 2.4GHz bandwidth for signal transfer. Both DECT and 2.4GHZ were developed for adult use, then
apply to baby monitors. Nuvita TULE, True Ultra Low Emission Technology, is Exclusively Developed for Baby
monitors having in mind that the baby's health is always our First Priority.
WARNING
NUVITA 3015 TULE STARRY AUDIO BABY MONITOR should not be regarded as a medical device. Premature
babies or those considered to be at risk should be under the supervision of your doctor or health personnel.
Direct supervision of your baby at a regular interval by a responsible adult is strongly recommended in
addition to using NUVITA 3015 TULE STARRY AUDIO BABY MONITOR.
DIGITAL TECHNOLOGY AND APRS
This baby monitor employs full digital technology with zero interference on standby.
The unit can automatically select free channel or hop to free channel during communication to avoid
interference from other electronic devices. In addition, thanks to the Automatic Power Reduction System
(APRS) which senses the signal strength between the baby and parent unit and automatically reduces the
emission power from baby unit when the two units are in close vicinity. The level of radiation to baby is greatly
reduced.
POWER SUPPLY
BABY UNIT
1. Operation from batteries
Pull up the support lever and slide open the
battery door in direction as shown. Insert 3
pieces AAA size (UM-4) alkaline batteries into
the compartment. Observe correct polarities
indication. Install back the battery door.
Note: For best performance, do not mix
use old and new batteries or alkaline and
rechargeable batteries.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for nuVita 3015 Starry
Summary of Contents for nuVita 3015 Starry
- Page 1 As a result, the level of radiation to baby is greatly reduced and always at the minimal level. Nuvita TULE technology helps to protect the baby’s health for now and future.
- Page 2 PARENT UNIT 2. Operation using AC adapter The unit can be operated on AC mains using the supplied 5V AC adapter. Connect the output plug of Power On/Off/vibration adapter to USB port 9 . The power supply from the battery will be cut off once the adapter’s output plug is selection ring inserted into USB port 9 .
- Page 3 PAIRING Adjust the microphone sensitivity using the “+ -“ button to acuire your desirable sound volume. The TRANSMIT indicator This process is to match the PU with BU and Baby motion sensor mat so that they can communicate with each will blink everytime these buttons are pressed, more number other while no other devices (even baby monitor of identical model) can interfere with you or receiving your of blinks mean the microphone is more sensitive to sound...
- Page 4 POWER ON BREATHING ALERT 1. WHEN THE PARENT UNIT IS PAIRED TO TWO BABY UNITS This feature is useful when the BU is paired to a Baby Motion Sensor Mat. Use buttons 15 16 to select between ON or OFF, press button 13 to confirm. Flashing ON –...
- Page 5 AMBIENT TEMPERATURE CLEANING Whenever the baby’s room temperature falls outside the range as preset by the high and low temperature Clean the Baby Monitor with a slightly damp cloth or with an anti-static cloth. limits, an alarm will be heard, icon “D” in red or white colour will show up and temperature reading starts Never use cleaning agents or abrasive solvents.
- Page 6 Starry night light projector and lullaby function on baby unit with capability to remotely control from parent unit and VOX mode supported The high and low temperature Set the high and low temperature Temperature alarm always on limit is set too close to the current limit around 5˚...
Need help?
Do you have a question about the 3015 Starry and is the answer not in the manual?
Questions and answers