Firstech FTX2400R-SS User Manual page 4

Quick Reference
When the battery on your 2 Way remote is low, you will no longer receive 2 Way confirmation in areas you usually do. Your remote will only send
commands to your vehicle. The LEDs on your 2 Way remote will also fade after transmission.
The only regular maintenance this system requires is remote control battery replacement. No programming is required when replacing the battery.
Two Way Remotes:
Use a quarter or flat head screwdriver to pry the back cover off of the remote. You can insert the quarter or flat head in the small slot at the bottom of the remote
by the keychain loop. Carefully pry off the back cover using caution that you do not damage the circuit board. Your battery size should be listed on the battery.
(Battery size: CR2450)
IMPORTANT: Be sure to observe correct polarity when installing the battery.
One Way Remotes:
Use a quarter or flat head screwdriver to pry the back cover off of the remote. You can insert the quarter or flat head in the small slot at the bottom of the remote
by the keychain loop. Carefully pry off the back cover using caution that you do not damage the circuit board. Your battery size should be listed on the battery.
Battery size: Two (2) CR2016) Replacements can be purchased from your local Firstech dealer or an electronics store.
By Firstech, LLC 6
Quick Reference
Button(s) Duration Function
Half second Locks doors and/or arms alarm.
3.5 seconds Panic/vehicle locater (flashes vehicle's
parking lights and sounds siren and horn).
Half second Unlocks doors and/or disarms alarm.
2.5 seconds Resets the run time or turbo timer
Half second Aux 1. Triggers the auxiliary 1 output
(most commonly used for rear defrost or window roll-down).
2.5 seconds Trunk release. Triggers the trunk release output and
opens the vehicle's trunk.
Half second Aux 2. Triggers the auxiliary 2 output (most commonly
used for rear defrost or window roll-down).
2.5 seconds Activates the remote start. Repeat and remote start will shut off.
Will activate Stop and Go Mode if held when vehicle is running
with the key.
Half second Turns siren chirps on/off (Note: With the siren chirps off,
it will still sound in the event the alarm is triggered).
2.5 seconds Option programming menu 1 - Installers Only.
LED Icon-Blue LED Icon-Red Chirp(s)
2nd Car Mode
Once
N/A
Twice
Three
Once
Twice
Once
Once On /
Twice Off
Once On /
Twice Off
Once
7 By Firstech, LLC