Installation - Losma Darwin 600 Series Instruction Manual

4.3. Installation

To mount the air filter, as well as the material supplied in the assembly kit, the following components are also necessary:
•
Flexible suction hose TFM of adequate length + 2 hose clamps
•
Flexible suction hose diam. 25 mm, TFD of adequate length + 1 hose clamp
•
In case the machine is enclosed, PRT pipe connection plate, nuts and bolts.
•
Find a suitable position for the installation of the air filter (on the machine tool or immediate close to it) and decide the
position of the air filter (vertical or horizontal) according to the available space or the shape of the machine cabin.
•
Drill the necessary holes to position the air filter on the machine cabin, as illustrated in the drilling schemes (enclosure
"Drilling schemes").
•
If the PRT pipe connection plate is necessary, drill the 4 holes, diam. 5, on the machine cabin, as illustrated in enclosure
no.3 "Drilling schemes".
Warning!
•
In order to avoid dangerous filtering of solid dust and coolant liquids, it is advisable to keep the suction hose
away from areas with a considerable presence of solid dust and sprays of coolant liquids.
•
To avoid pressure drop, it is advisable to use a suction pipe with a maximum length of 2 metres. Furthermore, to
prevent liquid stagnation inside the flexible pipes, avoid depressions when positioning it.
•
Insert an eyebolt of one of the supplied safety tie-rods, on the threaded pins of the anti-vibration joints.
•
Assemble the 4 anti-vibration joints on the previously drilled support surface, positioning the 2 joints - complete with
safety tie-rods - in a diagonal position, as indicated in drawing 3.
- If you have drilled clearance holes, fix the anti-vibration joints to the support surface by means of the washer and nuts
supplied.
- If you have drilled threaded holes, screw the anti-vibration joints directly on the support surface.
•
If foreseen, fix the PRT pipe connection plate to the machine tool cabin
•
Lift the air filter by means of the special eyebolt and position it on the anti-vibration joints.
•
Insert the other end of the 2 safety tie-rods on the threaded pin of the anti-vibration joints.
•
Mount the washers and nuts on the 4 threaded pins of the anti-vibrating joints.
•
Tighten firmly.
Drawing 3: Safety tie-rods assembly scheme
26
EN