Playing An Md Using A Timer - Sony MDS-JA30ES Operating Instructions Manual

Playing MDs
Fade-out playback
During playback, press FADE at the position where
you want fade-out playback to start.
"FADE OUT" flashes in the display and the deck
performs fade-out recording until the counter reaches
"0.0s."
The deck changes to play pause when fade-out
playback finishes.
Note on the peak level meters display during fade-
in/fade-out playback
The peak level meters show the level of the original
signal (input from the LINE(ANALOG) IN connectors
or output to the LINE(ANALOG ) OUT connectors and
the PHONES connector). Therefore, the level shown
on the meters does not increase or decrease ever as the
output fades in or out.
z
You can set the duration of fade-in and fade-out
playback independently
Do Steps 1 to 5 in "You can set the duration of the fade-
in and fade-out recording independently" on page 18.
z
You can select the type of increment/decrement curve
for fade-in/fade-out recording
Do Steps 1 to 4 in "You can select the type of
increment/decrement curve for fade-in/fade-out
recording" on page 18.

Playing an MD Using a Timer

By connecting a timer (not supplied) to the deck, you
can start and stop playback operations at specified
times. For further information on connecting the timer
or setting the starting and ending times, refer to the
instructions that came with the timer.
TIMER
POWER
g
TIMER
REC OFF PLAY
INPUT FILTER
PHONES PHONE LEVEL
OPT1
OPT2 • COAX
ANALOG
PLAY MODE REPEAT
0 10
PLAY MODE
1
Do Steps 1 to 3 in "Playing an MD" on page 7.
2
Press PLAY MODE repeatedly (or one of the
PLAY MODE buttons once) to select the play
mode you want.
To play only specific tracks, create a program (see
page 24).
28 EN
≠
EDIT/
NO YES
0 )
PUSH ENTER
SCROLL/ DISPLAY/
CLOCK SET CHAR
§
TIME
OPEN/CLOSE
(
3
• If you want to specify the time for the start of
playback, go to Step 4.
• If you want to specify the time for the end of
playback, press ( to start playback, then go to
Step 4.
• If you want to specify the time for both start and
end of playback, go to Step 4.
4
Set TIMER on the deck to PLAY.
5
Set the timer as required.
• When you have set the time for the start of
playback, the deck turns off. When the specified
time arrives, the deck turns on and starts
playing.
• When you have set the time for the end of
playback, playback continues. When the
specified time arrives, the deck stops playing
and turns off.
• When you have set the time for both the start
and end of playback, the deck turns off. When
the starting time arrives, the deck turns on and
starts playing. When the ending time arrives,
the deck stops playing and turns off.
6
After you have finished using the timer, set
TIMER on the deck to OFF.
Note
You can select Program Play in Step 2. Note, however, that
programs eventually fade away when the standby status is
off, and therefore if you set the time too far in the future, the
program may be gone when the specified time arrives. If
this has occurred, the deck enters normal play mode at the
specified time and the tracks play in consecutive order.
AMS ± DIGITAL ANALOG
REC LEVEL
0 5
4 6
3 7
2 8
1 9
– + 0 10
L R
( P p r
REC