Subscribe to Our Youtube Channel
Related Manuals for Image Engineering CAL3-XL
Summary of Contents for Image Engineering CAL3-XL
- Page 1 CAL3-XL User Manual 26. February 2019 Image Engineering GmbH & Co. KG · Im Gleisdreieck 5 · 50169 Kerpen-Horrem · Germany T +49 2273 99991-0 · F +49 2273 99991-10 · www.image-engineering.com...
-
Page 2: Table Of Contents
ADDITIONAL INFORMATION ..................10 5.1 Maintenance ......................10 5.2 Care instructions ......................11 5.3 Disposal instructions ....................11 TECHNICAL DATA SHEET ...................11 Image Engineering Error! Use the Home tab to apply Titel to the text that you want to appear here. Seite 2 von 11... -
Page 3: Introduction
Keep these instructions in a safe place and pass them to any future user. 1.1 Conformity We, Image Engineering GmbH & Co. KG, hereby declare, that the CAL3-XL corresponds to the essential requirements of the following EC directive in its current version: •... -
Page 4: General Safety Information
Figure 1: 4-prong alignment aid for CAL3-XL Optional equipment: • Available soon: iQ-Align-XL for CAL3-XL for a quick and easy camera alignment. • EX2 spectrometer for external measurments. • iQ-Analyzer software (shading module) This module includes a special chart layout file that allows analysis of images with and without a keyhole effect. -
Page 5: Operating Instructions Hardware
1 x port for power adapter Use the control panel to set different light settings for the iQ-LED´s: Figure 2: Control panel of CAL3-XL • with the “+” and “-“ buttons you can switch between up to 44 saved illuminants •... -
Page 6: Connecting The Hardware
2. Connect the USB cable to the CAL3-XL and your PC. 3. Turn on the CAL3-XL; the power switch is located beside the power supply. 4. Connect the spectrometer to the PC using the USB cable. The system will install the spectrometer and the iQ-LED drivers on your PC, this will take a few seconds. - Page 7 Error! Use the Home tab to apply Überschrift 1 to the text that you want to appear here. Figure 4: positioning of DUT in front of CAL3-XL Image Engineering Error! Use the Home tab to apply Titel to the text that you want to appear here.
-
Page 8: Using The Included 4-Prong Alignment Aid
90% for your measurements. Steps 1 - 5 (Figure 5) illustrate the process and how to position the DUT. The camera in this example uses a circular fisheye lens with an angle of view of 180°. The lens, not the CAL3-XL creates the visible keyhole effect. -
Page 9: Operating Instructions Software
Image Engineering support team. 4.3.2 iQ-LED calibration The individual LED lights of the iQ-LED inside the CAL3-XL depend on many different types and wavelengths. Some LEDs will change their intensity level and peak wavelength slightly in the first 500-600 working hours because of a burn-in effect. -
Page 10: Low Intensity Use
If a spectrometer calibration is necessary, please contact Image Engineering. We will provide you with removal instructions for the spectrometer. The spectrometer then has to be sent to our office with a notation for calibration. -
Page 11: Care Instructions
Only store and transport the CAL3-XL in the delivered hard case. 5.3 Disposal instructions After the service life of CAL3-XL, it must be disposed of properly. Electrical and electromechanical components are included in CAL3-XL. Observe your national regulations. Make sure that CAL3-XL cannot be used by third parties after disposing of it.
Need help?
Do you have a question about the CAL3-XL and is the answer not in the manual?
Questions and answers