GIZMO ENGINEERING T5 Instructions

DIGITAL TIMER INSTRUCTIONS (T5)
1. CONNECT POWER
2. SETTING THE TIME
• The blue buttons on the side adjust the time up and
down left of the colon.
• To program the digits right-of the colon, (usually
seconds) hold down the green "stop/start" button
then adjust the blue buttons.
3. SELECTING PROGRAM
• Switch #1 selects minutes /seconds in every case.
For minutes/seconds the switch will be to the RIGHT.
• Switches 2,3,4,5, select other behaviors according the
this table below. See detailed "mode chart" on our
website for further detail on the behaviors.
MODE SWITCH POSITION
1
1 L / R
2 L / R
3
L / R
4 L / R
5 L / R
6 L / R
7 L / R
8 L / R
9 L / R
10 L / R
11
L / R
12 L / R
13
L / R
14 L / R
15
L / R
16 L / R
2 3 4 5
R R R R
L R R R
R L R R
L L R R
R R L R
L R L R
R L L R
L L L R
R R R L
L R R L
R L R L
L L R L
R R L L
L R L L
R L L L
L L L L
FIRMWARE V. 51_510_01X
Page ! of !
UP
DOWN
MODEL T5
DESCRIPTION
EARLY WARNING ON LED1 (DEFAULT)
MANUAL STOP - CANNOT CANCEL CYCLE
MECHANICAL TRIGGER WITH EARLY WARNING
PAUSING (ACCUMULATES TIME AFTER STOPPING)
AUTOMATIC CYCLE STOP (WITH CANCEL)
EARLY WARNING ON LED2
GUARD DUTY
SRAY RINSE - MECH. TRIGGER
MACHINE HOURS TOTAL
ON-DELAY
REPEAT
FUTURE USE
FUTURE USE
FUTURE USE
FUTURE USE
FUTURE USE
SWITCHES FOR SELECTING MODES
1 2
START / STOP