Oregon PH600 Original Instruction Manual page 15

Multi-attachment powerhead
Hide thumbs Also See for PH600:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Battery Pack and Charger
WARNING: To reduce the risk of shock, do
not charge the battery pack in the rain.
BATTERY PACK LED CHARGE-
LEVEL INDICATOR
The lithium ion battery pack is equipped with an
LED charge-level indicator To test the charge
level of the battery pack, press the indicator
button on the battery pack's face
No lights: recharge
One steady green light:
less than 25% charged
Charge battery pack before use
Two steady green lights:
26–50% charged
Three steady green lights:
51–75% charged
Four steady green lights:
76–100% charged
INDICATOR BUTTON
INDICATOR LIGHTS
CONNECTING THE CHARGER
If the charger includes a separate power cord,
connect the charger cord to the charger and to the
proper electrical outlet
Only use the cord set that was supplied with
the charger At first use, verify that the plug type
matches the receptacle
Multi-attachment Powerhead
Battery Pack and Charger
CHARGER LED CHARGE-STATE INDICATOR
The battery charger is equipped with an LED
charge-state indicator that indicates the state of
charging as well as conditions that may delay or
prevent charging
Note: Until a battery pack is inserted, no lights will
be visible
Blinking orange light: a fault condition
exists There are several potential causes
See "Troubleshooting" in this manual
Steady orange light: the battery pack
temperature is beyond the acceptable
range (32°F/0°C to 104°F /40°C) Allow
the battery pack to reach the acceptable
temperature range before charging The
pack may be left on the charger as the
temperature adjusts Charging will begin
when the proper temperature is reached
Blinking green light: battery pack is
charging
Steady green light: battery pack is ready
for use
CHARGING THE BATTERY
WARNING: Failure to follow proper
charging procedures may cause excessive
voltage, excessive current flow, loss of
control during charging, leakage of hazardous
chemicals, heat generation, bursting or fire.
Follow these charging instructions.
With the charger cord connected to the charger
and plugged into a electrical outlet, align the
grooves on the battery with the rails on the
charger and slide the battery pack onto the
charger until fully seated
For more information, please refer to your
battery and charger manuals.
15

Advertisement

Table of Contents
loading

Table of Contents