Duraflame DFH-IH-12-O Homeowners Operating Manual page 6

OPERATION INSTRUCTIONS
1. Place the product upright on a flat, level, stable, heat-resistant surface, and then plug
the Power Cord into a standard 120-volt electrical outlet.
2. Main Control Knob: Use this knob to set the heat setting (Figure B):
"I" – Low Heat Setting (400 Watts)
"II" – High Heat Setting (800 Watts) "
3. Timer Knob: Use this knob to use the timer function (Figure B):
"ON" – The heater will remain on and the timer function is disabled.
"OFF" – The set time has expired and the heater function has turned off accordingly.
"20~120" – The set minutes remaining for the heater to turn off when the timer
function is in use.
4. Turn off the product by rotating the Main Control Knob to the "OFF" position, and
then unplug the product from the electrical outlet.
WARNING: Always unplug the product when it will be left unattended or not in use.
WARNING: Do not force the control knobs beyond their normal stop positions.
Safety Protection Systems
This product has protection safeguards that shut off the product when parts become
excessively hot or if it tips over. If the product shuts off, immediately turn the Control to
the "OFF" position and unplug it from the electric outlet.
If overheated:
a. Remove any objects near the product that may cause overheating. Use the product
in a well-ventilated area. Keep at least 3 feet (0.9 meters) of space on all sides
of the product to allow adequate air circulation.
b. Allow the product to cool down for at least 10 minutes before plugging it back into
an electric outlet for re-use.
If tipped over:
Place the product on a flat, level, stable surface in order to prevent the product from
tipping over again.
TIP: Always install and maintain at least one smoke detector in good operating
condition on each floor of your home. Periodically check and/or replace the battery in
your smoke detector with a new battery.
" " – Low Heat Setting with Oscillation
" – High Heat Setting with Oscillation
E-5