Naish Fusion 5-Line Manual page 16

V - CONTROL SYSTEM BAR
2) ADJUSTING BASE BAR STEERING (REAR) FLYING LINES
Repositioning the leader lines on the knots under the floaters
changes the length of the steering (rear) flying lines.
Step 1: Pull the floaters up to expose the leader line
adjustment knots.
Step 2: Adjust the leader line to the desired knot position.
Knot A: Increases the length of the Steering (Rear) Flying
Lines (+5cm).
Knot B: Naish Control Systems are delivered in the
Knot B position.
Knot C: Decreases the length of the Steering (Rear) Flying
Lines (-5cm).
Step 3: Pull the floaters down to cover the leader line
adjustment knots.
IMPORTANT: Repeat this procedure on the opposite bar end so
the leader line length adjustment is done exactly the same on
both sides.
V - CONTROL SYSTEM BAR
3) ADJUSTING FUSION BAR WIDTH
A) Pull the bar/line adjuster out of the bar end
as shown.
C) Reinstall the bar/line adjuster by pushing it back
into the bar end, while pulling the leader line above
the floater to remove any slack as shown.
IMPORTANT: Repeat this procedure on the opposite
bar end so the bar width adjustment is done exactly
the same on both sides.
A
B
C
B) Rotate the bar/line adjuster 180 degrees as shown.
17
NAISHKITES.COM