Removing The Bluetooth Module (C) (See Fig. 3); Removing The Speaker (See Fig. 3); Removing The Speaker Bracket - Packard Bell Compasseo 800 Disassembly Manual

Fig. 5 Disconnecting the microphone cable
Note
When removing the main board from the casing, watch the volume switch,
as it might come off. When reassembling, put back the switch first before
closing the device.

Removing the Bluetooth module (C) (see fig. 3)

In order to properly remove the speaker, first unscrew the Bluetooth module.
To unscrew the Bluetooth module, perform the following:
1. Remove the top right screw of the Bluetooth module.
2. Gently lift the Bluetooth module from the main board, but do not yet
disconnect the Bluetooth cable from the main board.
You will only be able to fully disconnect the Bluetooth module once the
speaker and the speaker bracket are removed.

Removing the speaker (see fig. 3)

Follow these steps to remove the speaker:
1. Remove the two screws on the left and right side of the speaker.
2. Lift the speaker and disconnect the speaker cable from the main board.

Removing the speaker bracket

Remove the speaker bracket as follows:
Compasseo 800 Disassembly Manual 7