Sony PCV-L630 Computer User Guide (primary manual) Reference Manual page 50

42
VAIO Computer Reference Manual
4
Unplug the ribbon cable and power supply cable from the hard drive
connectors.
5
Remove the four screws that secure the hard drive to the bottom of
the drive carrier.
6
Remove the hard drive from the drive carrier.
7
Set the jumpers on the new hard drive to be the Primary Master IDE
drive (refer to the instructions that came with your new hard drive).
8
Insert the new hard drive into the drive carrier.
9
Replace the four screws that secure the drive to the drive carrier.
Be sure you reattach the ground tab at the position shown in the illustration.
10
Reconnect the ribbon cable and power supply cable to the new hard
drive.
Be sure to insert the ribbon cable inside the plastic stress-relief slots on the drive carrier.
MAN004.VSD