Advertisement
Once you have the 3mm screw in all the way, continue turning the screw a few times so that the screw
thread can drill out the hole a bit more. You can now easily fit your 25mm (1 inch) brass hex spacers.
Use your pliers if necessary to hold the brass spacers when tightening the screws. Do not
overtightenotherwise you will crack the servo mounts.
Step 9. Attach the pan servo to the pan bracket
The pan / tilt kit comes with two large brackets. Each bracket has a different hole pattern on it to suit
many different sensors. Look at the photo below and make sure you attach the correct bracket to the
pan servo as the compound eye cannot be mounted if you use the wrong bracket.
The assembly instructions for the pan / tilt kit are included in the kit. They can also be downloaded
from myproduct support site . Use 2 x 6mm pan head servos to mount the bracket to the round servo
horn and another 2 x 6mm pan head to mount the servo horn onto the pan servo as shown.
Step 10. Attach the tilt servo locating bracket
The tilt servo locating bracket doesn't actually hold the tilt servo in place. It's main purpose is to
prevent the tilt servo from twisting while allowing some play so the servo can self center.
Advertisement
