Troubleshooting - Santint S5 User Manual

Issue
No message on LCD.
LCD displays "Clamping
System Trouble".
The DC motor stops work
after several rounds
rotation and LCD displays
"Clamping System
Trouble".
The machine cannot shake
big container.
LCD Displays "Emergency
Button Pressed".
LCD displays "Door Open".
LCD displays "Initializing"
right after the AC motor is
started.
No shaking while
clamping system works
well.
Extreme vibrations
noises during shaking.
After clamping,
displays "Shaking".
main motor produces noises
and time-counting is still on
as usual but shaking cannot
proceed.
LCD shows "Motor
Overheat".
Automatic Shaker

8. Troubleshooting

Cause
Power supply in trouble.
Broken fuse/power line.
DC motor wire in trouble.
Circuit board in trouble.
Magnetic switch wire in trouble.
of
Magnetic switch is defective.
Loose V-belt.
Emergency stop button is pressed.
Emergency stop is defective or its
connection wire is broken.
The door is not closed well.
Electric mortise lock in trouble.
Too thin wiring for mains power
supply.
the AC motor capacitor in trouble.
AC motor in trouble.
The machine is not leveled.
and
Deformation of the paint can.
Overloaded.
LCD
The
Starting capacitor is damaged.
Shaker works under improper
voltage (too high or too low) for
too long time.
Santint
Check the socket; plug; and
switch.
Replace the fuse/power line.
Replace it.
Replace it.
Replace it.
Replace it.
Tension it.
Release it.
Replace it or connect the
wire.
Close it.
Replace it.
Replace the wiring by a thick
one or install a voltage
stabilizer.
Replace it.
Replace it.
Adjust the feet to level it.
Replace it.
Reduce the load.
Change the position of the
switch on the capacitor union.
1. Power off the machine to
lower temperature. Restart
the machine after one hour.
2. Install a voltage stabilizer.
3. If the phenomenon occurs
frequently, check electrical
circuit.
V1.0
Solution
9