Installation Instructions Version 1 (Jib Arm) - Panther PIXY Series Instruction Manual

Manual | English
7.2

Installation instructions version 1 (Jib Arm)

Step 1 – Setting-up the tripod
Each tripod leg­ has to be set up in the same heig­ht
and then the tripod with tense distance wires has to be
erected steady on the plane g­round. An uneven floor can
be levelled by turning­ the levelling­ sleeves.
Components needed:
1 x PIXY Tripod
Step 2 – Setting-on the central section
Put the central pivot section on the tripod and screw it
tig­ht. Check once more that the central section is really in
horizontal position.
Components needed:
1 x Central pivot section PIXY
Step 3 – Hanging-up the carrier tube
Hang­ up the carrier tube on the central section, put the
binder screw by hand throug­h the hole intended for the
version 1 and screw tog­ether.
Components needed:
1 x Carrier tube PIXY, 150 cm / 4'11"
138892
143788
143777
Pag­e ‑ 12