Step 7: Adjust Tension - Sony SU-WTS1 Dealers Installation Manual

Step 6: Mount the TV to the Mount Wall Brackets
1
With the upper tilt hooks on the mounting arms (A) in the flat position, raise the TV with mounting arms (A)
attached (2 people minimum recommended) and place the TV flat against wall with the upper and lower mounting
arms (A) attaching slots slightly higher than the steel receiving rods of the upper and lower mount wall brackets
(B).
2
With the TV reasonably level, lower the TV until the mounting arms (A) receiving slots are fully installed into the
upper and lower mount wall brackets (B) steel rods. Gently pull the left and right upper edges of the TV to extend
the mount to its maximum 10° tilt and install the four 6 mm safety knobs (D) on each mounting arm (A) for
security.
Note
To remove the TV from the wall, simply extend the TV to its maximum tilt range, remove the four 6 mm safety knobs (D) push the TV back to its flat
wall position and lift the unit up and out from the wall.
Wall structure
B
Caution
Be sure to install the four safety knobs (D) to prevent the TV from falling down.

Step 7: Adjust Tension

Tension:
To adjust the tilting tension, tighten the 5 mm screws on both sides of the brackets.
D
M5 tension
screw
D
8
A
A
Wall structure
D
Safety knob
A
D
Safety knob