Sony SU-LW1 Instructions (SU-LW1 Wall-Mount Bracket) Instructions Manual page 13

Step 5: Detach the display from the Tabletop Stand
The procedure differs depending on the display model. Apply the procedure
appropriate for the display you are installing.
KLV-26HG2
1Pull the lower corner (either right or
2Hold the rear cover with both hands
Note
Lay the display face down on a soft cloth
before going to 3.
3Remove the two small screws from
4Remove the five screws from the
5Lift up the Stand slightly, then pull it
Notes
• Lay the display face down on a stable
• When removing the Tabletop Stand,
left ) of the rear cover. Then pull the
other lower corner.
and pull it towards you. The rear
cover will separate from the display.
the clip. Detach the clip from the
Tabletop Stand.
Tabletop Stand.
towards you. The Stand will separate
from the display.
and level surface, leaving the base of
the Stand sticking out in the air.
Putting the display face and the base
of the Stand on the same level surface
makes the Display Unit inclined, thus
unstable, causing any danger.
hold it firmly.
1
2
3
Soft cloth
Screws
removed in 4
4
5
Clip
13
(GB)