Sony SU-LW1 Instructions (SU-LW1 Wall-Mount Bracket) Instructions Manual page 12

3
Arm
Tilt adjuster
Arm bases
A and B
12
(GB)
1
2
Adjust the tilt of the arms.
If you want to install the display vertically, flush with
the wall (0°), skip 1 and 2 below. Check that the
arms are securely attached to the Plate Unit.
1Remove all four tilt adjusters.
2Put them into the screw holes corresponding to the
desired angle (5°, 10°, 15°, or 20°) and tighten them
firmly.
Notes
• The angle of the left and right arms must be the
same.
• Be careful not to catch your fingers when adjusting
the angle of the arms.
• When using an electric screwdriver to tighten the
screws, the torque must be approx. 2 N
• Check that the arm bases are securely attached to
the Plate Unit.
m.
•