Sony SRSDZ10 Operating Instructions Manual page 72

[FRONT]
[CENTER]
[SURROUND]
[SUBWOOFER]
Note
• When you select an item, the sound cuts off for a
moment.
x [DISTANCE]
The default distance setting for the speakers in
relation to the listening position is shown below.
When you set the distance using the Quick Setup
(page 25), the settings is automatically
displayed.
1.0 - 7.0 m/
4 - 23 ft
Be sure to change the value in the Setup Display
when you move the speakers.
[FRONT]
3.0 m/10 ft*
[CENTER]
3.0 m/10 ft*
(appears when
you set
[CENTER] to
[YES] in the
[SIZE] setting.)
72
GB
[YES]
[YES]: Normally select this.
[NONE]: Select this if no center
speaker is used.
[BEHIND]: Select this if surround
speakers are located in section B.
[SIDE]: Select this if surround
speakers are located in section A.
[NONE]: Select this if no
surround speaker is used.
[YES]
0.0 - 7.0 m/
0 - 23 ft
Front speaker distance from the
listening position can be set in 0.2
meter (1 ft) increments from 1.0 to
7.0 meters (4 to 23 ft).
Center speaker distance from the
listening position can be set in 0.2
meter (1 ft) increments from 0.0 to
7.0 meters (0 to 23 ft).
[SURROUND] Surround speaker distance from the
3.0 m/10 ft*
listening position can be set in 0.2
(appears except
meter (1 ft) increments from 0.0 to
when you set
7.0 meters (0 to 23 ft).
[SURROUND]
to [NONE] in the
[SIZE] setting.)
* When you perform the Quick Setup (page 25), the
default settings are changed.
Note
• When you set the distance, the sound cuts off for a
moment.
• If all front and surround speakers are not placed at an
equal distance from your listening position, set the
distance according to the closest speaker.
• Do not place the surround speakers farther away from
your listening position than the front speakers.
• Depending on the input stream, the [DISTANCE]
setting may not be effective.
x [LEVEL (FRONT)]
You can vary the level of front speakers as
follows. Be sure to set [TEST TONE] to [ON]
for easy adjustment.
[L] Set this between –6 dB and 0 dB
0 dB
in 1 dB increments.
[R] Set this between –6 dB and 0 dB
0 dB
in 1 dB increments.
[CENTER]
Set this between –6 dB and +6 dB
0 dB
in 1 dB increments.
(appears when you
set [CENTER] to
[YES] in the [SIZE]
setting.)
[SUBWOOFER] Set this between –6 dB and +6 dB
0 dB
in 1 dB increments.
x [LEVEL (SURROUND)]
You can vary the level of surround speakers as
follows. Be sure to set [TEST TONE] to [ON]
for easy adjustment.
(This settings appear except when you set
[SURROUND] to [NONE] in the [SIZE]
setting.)
[L] Set this between –6 dB and +6 dB in
0 dB
1 dB increments.
[R]
Set this between –6 dB and +6 dB in
0 dB
1 dB increments.