Table of Contents
Advertisement
Always switch OFF the user system and the emulator
product before the EXPANSION I/O BOARD or USER
SYSTEM INTERFACE CABLE is connected to or removed
from any part. Before connecting, make sure that pin 1 on
each side is correctly aligned. Failure to do so will result in
a FIRE HAZARD and will damage the user system, the
emulator product, the user system interface cable, and the
expansion board, or will result in PERSONAL INJURY. The
USER PROGRAM will be LOST.
2.1
Using Emulator without Connecting User System
1. Make sure the emulator is turned off.
2. After making sure the direction of the expansion I/O board connector labeled E6000
EMULATOR is correct, firmly insert the expansion I/O board connector into the emulator
station connector. When the emulator is operated while connected to only the expansion I/O
board (without connecting the user system), disconnect the cable body from the expansion I/O
board.
Section 2 Connection Procedures
WARNING
5
Advertisement
Table of Contents
