Installing The Speakers On The Wall - Sony HT-SF800M Operating Instructions Manual

Tips
• Since the subwoofer does not emit highly directional
signals, you can place it wherever you want.
• (Except for HT-SF800M) For greater flexibility in
the positioning of the speakers, use the optional
WS-FV11 or WS-FV10D floor stand (available only
in certain countries).
Attaching foot pads
(Except for HT-SF800M)
To prevent speaker vibration or movement,
attach the supplied foot pads to the speaker as
shown in the illustration below.
Note
Be sure to attach the supplied foot pads to the
subwoofer as well.
Installing the speakers on the
wall
You can install your front and surround speakers
on the wall.
1
Prepare screws (not supplied) that are
suitable for the hole on the back of
each speaker. See the illustrations
below.
more than 25 mm
4.6 mm
10 mm
Hole on the back of the speaker
more than 4 mm
2
Fasten the screws to the wall. The
screws should protrude 5 to 7 mm.
5 to 7 mm
3
Hang the speakers on the screws.
Hole on the back of the speaker
Notes
• Use screws that are suitable for the wall material and
strength. As a plaster board wall is especially fragile,
attach the screws securely to a beam and fasten them
to the wall. Install the speakers on a vertical and flat
wall where reinforcement is applied.
• Contact a screw shop or installer regarding the wall
material or screws to be used.
• Sony is not responsible for accident or damage
caused by improper installation, insufficient wall
strength or improper screw installation, natural
calamity, etc.
4.6 mm
10 mm
continued
13 GB