Fcc Compliance Statement - TECTUS RFID MultiPen User Manual

TECTUS Transponder Technology GmbH, Eurotec-Ring 39, 47445 Moers 7 Germany

FCC compliance statement

These devices comply with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. These devices may not cause harmful interferences;
2. These devices must accept any interference received, including interference that may cause
undesired operation.
The following figures list the Grant by FCC ID Number for each of the following devices:
FCC ID: 2APYK-MULTIPEN3
Please refer to the FCC's website (http://www.fcc.gov) to view the grant and related
documentation.
CAUTION !
Exposure to Radio Frequency Radiation. The radiated output of this device is far below the FCC
radio frequency exposure limits. Nevertheless, the device shall be used in such a manner that the
potential for human contact during normal operation is minimized. These devices may not be co-
located with any other transmitter or transmitter antenna.
NOTE:
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interferences when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the operation manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own
expense.
Changes or modification not expressly approved by TECTUS could void the user's authority to
operate the equipment described in the manual.
This device contains Bluetooth™ module FCC ID: T9JRN41-3
MultiPen User Manual V.1.2 ©TECTUS Page 3 / 10