Getting Started Setup - Valon UPS6V-2 Operation Manual

5 Getting Started Setup

The figure below illustrates a typical user setup.
Figure 2 Typical Setup
Connect the UPS6V-2 to the 6V load (synthesizer typically) as shown in Figure 2 using the supplied
double ended Hirose cable. The 6V OUT from the UPS6V-2 should be connected to the +6Vdc input of
the synthesizer as shown.
Then connect the pig-tail end of the supplied Hirose cable to the power supply or ac adapter. Note that
2.1mm x 5.5mm barrel power plug adapter is available from Valon for connecting ac adapters to the pig-
tail end of the Hirose power cable. Plug this cable into the UPS6V-2 and apply power from the power
supply or ac adapter.
PS6V-1 Power Supply Kit http://www.valontechnology.com/accessories.html
Let the power supply charge the battery completely before first use.
Note that both the RED, GREEN, and BLUE LED should be illuminated. The Red LED indicated the battery
is being charged and should extinguish once the battery is fully charged and the charger has entered the
final constant voltage mode.
Once the battery is fully charged, the power supply can be switched off or disconnected. To turn the
boost converter on and apply power to the load, press the push-button switch once. The BLUE LED
should illuminate indicating that boost converter is working and supplying output power from the
battery.
The power source can be re-applied at any time and the UPS6V-2 will automatically shut down the boost
converter and start charging the battery as indicated by the GREEN and RED LEDs. The boost converter
will automatically restart if the power source is disconnected or turned off.
www.valontechnology.com 7 5/13/2016